Chainsaw mill Revision three
Finally got my third mill revision into service. Works well.
Started on a four foot x 20 in diam maple log and was able to get nice flat slabs and square edges. I can use the guide for multiple cuts by adding or removing spacers.
Pictures when I get some.
Egon [img]/forums/images/icons/grin.gif[/img] [img]/forums/images/icons/grin.gif[/img]
1 Attachment(s)
Re: Chainsaw mill Revision three
1 Attachment(s)
Re: Chainsaw mill Revision three
1 Attachment(s)
Re: Chainsaw mill Revision three
1 Attachment(s)
Re: Chainsaw mill Revision three
Re: Chainsaw mill Revision three
Hey, Egon. That looks like it would work good. I need you to bring that thing down here to North Carolina and cut up a couple cedar logs for me. I want to make my front steps out of 4"X 10" cedar. I have a couple local mills that will cut it for me, just havn't had the time to take it to them.
How does it work starting from a round log?
Later, Nat
Re: Chainsaw mill Revision three
I have a nice set of jeans just like yours, but about that right boot ... envy!
Re: Chainsaw mill Revision three
Just be poor and the boots will look like that. Red Wings No less.
Those were a good pair of jeans by the way. [img]/forums/images/icons/grin.gif[/img]
Egon [img]/forums/images/icons/grin.gif[/img]
Re: Chainsaw mill Revision three
The picture you saw started from a sorta round log!
Egon
Re: Chainsaw mill Revision three
Hey Egon, will revision four include a longer guide bar? It looks like you're limited now. (The picture makes it difficult to tell how long your maximum length of stock could be.)