Search:

I've gotten a ton of use out of my DW705 12" non-sliding. Enjoy the big daddy.

But the 4 wire isn't required for power tools? - they don't have a nuetral.

<font color="blue"> Seems there are some things about wiring that you are missing (sorry to be so blunt) </font color>

You're right, I am missing some things. /forums/images/icons/grin.gif Don't...

Didn't find any 12-2 with black, red ground at the home center.

Wiring a few 220V, 20AMP outlets for the workshop - dust collector, compressor (smaller craftsman- hopefully I can convert it from...

Main Panel is 200 amp.

Thanks guys,

You've got me a little worried about my 100amp feeder.

An air conditioner will be run off the sub panel for the attic (220V 20-30amp?). I also plan on adding a large circuit for a...

Close up of how ground is attached to main panel. Is the little square fitting a seperate piece? How do I tie in the 2 AWG nuetral for the sub panel?

Thanks!

100AMP double throw will go here

Hey guys

I'm adding a 100 amp sub panel for my basement shop. Also need some extra breakers for the attic addition.

I plan on removing the lower two circuits from the main panel and putting...

Thanks guys. I also found this one MLCS Boomer Bar

The true-grip has an 8' section, the MLCS only goes to 50"

Thanks guys. Keep the suggestions coming...

Thanks rob. I need to sit with the CFO and lay out a budget for this project. It's obvious that I need lots of tools, but also need the HVAC, electric, walls, and carpet.

I built fence wings for my miter say, but they are anything but portable. I'm hoping to make them into a permanent bench in the shop someday.


Any recommendations on ready made <font...

Figure I'll be using as much plywood as possible for my built in construction. Anybody got good/cheap panel saw plans.

Any alternatives - I seem to remember something about laying a sheet of 2"...

Wanted to keep these threads seperate to aid future user's searching for knowledge.

Thinking about a jointer &amp; planer to aid in built in furniture construction - shelves, cabinets, drawers. Not...

Finishing the attic this winter. Looking to do a bunch of built ins in the kneewalls. Of course this will require some new tools. /forums/images/icons/tongue.gif

Tool 1, Router &amp; table. Which...

Thanks guys.

Murph any brands you recommend? I assume they need 220V, large amperage electric service?

Have a walk up "attic" aka the third floor. it has three dormers and a window on the end - about 12-14' headroom. It is designed to be a bonus room, but was never finished. I call it the rumpus...

2 &amp; 1/2 for, 2 against. The aye's have it. (Gary your "vote" sealed the deal)

Since sears was kind enough to have a craftsman club sale starting today I picked up the Bostitch BT200 I went with...

Wife is on me to finish up downstairs project.

Question - Is shoe molding a good excuse to pick up an 18ga pnuematic brad nailer? Or will my 15ga angled finish nailer do the job? I'm worried...

Thanks Rob. Something tells me that I'll get to help out. I've started researching rotary cutters already /forums/images/icons/tongue.gif My pops might even pay for it - in exchange for free labor...

side of house &amp; garage

kubota

inside barn

field towards road