I'm looking for a MIG that I can use on 110v, with at least a 20% duty cycle at 75-100 amps for light duty use. I've got a stick welder and ox-ac setup that I can do heavier stuff and cutting with, but I'd like something for the thinner gauge materials.
Cost is very much an issue and I plan on being able to use it not only inside but also with my portable generator for things that I cannot move into the shop. The generator's rated for 6500w running/7200 peak.
I'm not so sure that I really need gas capabilities with the MIG - I "think" that flux-core or regular steel wire should suffice for most of my welding needs.
Any and all advice is appreciated!