So you wanted to know how to make a fish mouth? If its 1/16" thick,you had better get it fitting pretty good,or you will burn some holes when you weld it.On sch.40 type 2",I never used a template because you don't have to moon out much,I always staddeled the pipe end and in the top edge cut back maybe a 1/2" and than cut out to each edge that you can see,you got to be directly above the end,with you eyes,to make this work,than roll it 180 degrees and do the exact same thing to the other side,than you adjust your cutback as needed and its always needed,but once you get it you can whip em out,now this was heavier stuff and if I had a little gap,I just took my time and didn't burn a hole,but you did say this pipe was 1/16" wall thickness didn't you? RICHARD GAUTHIER