Chainsaw mill Revision three

[egon]

Finally got my third mill revision into service. Works well.

Started on a four foot x 20 in diam maple log and was able to get nice flat slabs and square edges. I can use the guide for multiple cuts by adding or removing spacers.

Pictures when I get some.

Egon [img]/forums/images/icons/grin.gif[/img] [img]/forums/images/icons/grin.gif[/img]

[egon]

A picture.

Egon

[egon]

Picture two

Egon

[egon]

Picture three.

Egon

[egon]

Picture four.

Egon

[Nat]

Hey, Egon. That looks like it would work good. I need you to bring that thing down here to North Carolina and cut up a couple cedar logs for me. I want to make my front steps out of 4"X 10" cedar. I have a couple local mills that will cut it for me, just havn't had the time to take it to them.
How does it work starting from a round log?
Later, Nat

[SLOBuds]

I have a nice set of jeans just like yours, but about that right boot ... envy!

[egon]

Just be poor and the boots will look like that. Red Wings No less.

Those were a good pair of jeans by the way. [img]/forums/images/icons/grin.gif[/img]

Egon [img]/forums/images/icons/grin.gif[/img]

[egon]

The picture you saw started from a sorta round log!

Egon

[JazzDad]

Hey Egon, will revision four include a longer guide bar? It looks like you're limited now. (The picture makes it difficult to tell how long your maximum length of stock could be.)