I was given a David Bradley Hammer Mill in real good shape , except the belt needs replaced, and it is missing the outlet spout. Is anyone familiar with this equipment, and where parts may be found? thanks
[img]/forums/images/icons/tongue.gif[/img] The outlet spout COULD be what they call a "cyclone"....a funnel-shaped device with an air outlet on top and a ground grain discharge on the bottom. The cyclone basically gets rid of the 'wind" and gives you the grain. [img]/forums/images/icons/tongue.gif[/img]
yes, cjdave, thank you, I could not remember what the cyclone was called, the older I get, the worse my memory is. There are small mills all around my area, just not this brand. I'll figure something out.thanks for the replies
This is a reply to an old post you had on your hammer mill. If you are still registered & get this reply I'm looking for some information on a mill I just bought. Thanks