I went out to the shop and took some more pics as more progress has been made. This shows how I have the anchor end cyl mount made. I have a piece of 5" chanel across the subframe on the bottom side at the back of the tongue and another 30" farther back, both are under the subframe. I then ran 2 pieces of 3" chanel from where the tongue crosses the front of the subframe back to the botton of the first 5" chanel. I then ran a piece of 5" chanel flat under these from where the 3" chanel connects to 4" past the rearward chanel. This is where the anchor for the cyl fits. In order for this mount to move it has to push the mount back, and that is stopped by the 3" chanel. The 5" chanel is welded under the subframe and just welding it isn't enough so I made these brackets to give me more welding surface. They weld inside the subframe and weld vertically to the cross chanel. I hope this pic shows what I mean. later, Nat